Begadi Pinion Remover Tool (puller for Pinion Gears)
This tool can be used to remove tight-fitting Pinion Gears (O-Type + D-Type) from the motor shaft. No load is applied to the shaft so as not to damage the Motor.
The tool is made of robust steel and can be used for all Motors (including Brushless)
Clamp the Pinion Gears into the tool as shown below. Then use a screwdriver to turn the thread downwards.
Make sure that it exerts pressure in the center of the shaft. The pinion is driven off the shaft by turning it.
ATTENTION: If your Pinion is secured with a screw, this must be removed first.
The tool is made of robust steel and can be used for all Motors (including Brushless)
Clamp the Pinion Gears into the tool as shown below. Then use a screwdriver to turn the thread downwards.
Make sure that it exerts pressure in the center of the shaft. The pinion is driven off the shaft by turning it.
ATTENTION: If your Pinion is secured with a screw, this must be removed first.






