Begadi Sticker set made of PVC in industrial quality, 2x 60mm Ø & 3x 100mmx34mm, with high adhesive strength
-
3D badge "ROEDALE" hard rubber, with velcro - blackSpecial Price €1.50 Regular Price €1.90
Stickers were for a long time on place -one- of the wish list for merchandising, but for us it was clear that the quality must not take a back seat here. Therefore, we have worked here with a German partner to achieve the best possible quality!
Our stickers are manufactured in Germany in industrial quality. They have a long life, are resistant to environmental influences and also adhere very well to uneven and sometimes porous surfaces. Due to the high adhesive strength, they do not come off the carrier sheet too easily, please note our tips below - for this, they stick very well later and do not come off as quickly as cheaper stickers
Size:
- round sticker: 60mm diameter
- rectangular sticker: 100mm x 34mm
Since our stickers are normally used in industry, they are of higher quality than common stickers on the market, which is clearly reflected in the adhesive strength and UV resistance. As with all plastics, the colors can change somewhat over a very long period of time, especially if they are permanently exposed to the sun. However, a long-term test that is still in progress shows very good results so far (over 2 years and no change!).
The life span of the carrier film tested by the manufacturer was 7 years!
Facts and data:
- size of the stickers: 60mm diameter (round) or 100x349mm (square)
- PVS base: ORAJET® 3106SG High Performance Polymer PVC Film
- Thickness: 100 Micron
- Temperature resistance: -50°C to +100°C without degradation
- Salt water resistance: Tested at 100h continuous exposure
- Resistance to chemicals: After 72h application briefly resistant to oil, grease, weak acids, salts and alkaline liquids
Our stickers are manufactured in Germany in industrial quality. They have a long life, are resistant to environmental influences and also adhere very well to uneven and sometimes porous surfaces. Due to the high adhesive strength, they do not come off the carrier sheet too easily, please note our tips below - for this, they stick very well later and do not come off as quickly as cheaper stickers
Size:
- round sticker: 60mm diameter
- rectangular sticker: 100mm x 34mm
Since our stickers are normally used in industry, they are of higher quality than common stickers on the market, which is clearly reflected in the adhesive strength and UV resistance. As with all plastics, the colors can change somewhat over a very long period of time, especially if they are permanently exposed to the sun. However, a long-term test that is still in progress shows very good results so far (over 2 years and no change!).
The life span of the carrier film tested by the manufacturer was 7 years!
 Attention:Information about removing the stickers from the carrier sheet and about the substrate Please follow this information when applying the stickers. |
| The substrate should be clean, dry, load-bearing, free of grease and dust, the smoother the substrate the better the adhesion. ATTENTION: Please note the high adhesive strength of the stickers! Painted surfaces are very likely to be damaged when removing the sticker! Instructions for removing the stickers from the carrier sheet: 1. Press sticker downwards out of the carrier sheet. 2. Now bend the sticker slightly in the edge area and use your fingernail to detach the sticker from the backing sheet. This requires a bit of fine-tuning and fingertip feeling, as the sticker adheres very well to the carrier. Tip: What also works very well is to use a pointed object (needle, tweezers, knife tip, etc) to separate the sticker from the carrier The full adhesion and adhesive strength is achieved about 72h after application! In permanent sunlight, the colors of the stickers may change minimally and the adhesive strength may decrease |
Facts and data:
- size of the stickers: 60mm diameter (round) or 100x349mm (square)
- PVS base: ORAJET® 3106SG High Performance Polymer PVC Film
- Thickness: 100 Micron
- Temperature resistance: -50°C to +100°C without degradation
- Salt water resistance: Tested at 100h continuous exposure
- Resistance to chemicals: After 72h application briefly resistant to oil, grease, weak acids, salts and alkaline liquids
Review Partner