Begadi CNC HopUp adapter for E&C SMR17 / SMR28
CNC machined aluminum HopUp adapter, suitable for E&C SMR 17 and SMR 28.
With this adapter, for example, our Begadi NEPTUN CNC HopUp Unit can be used in both guns.
The adapter uses the front passage (cable guide) to extend the outer barrel.
It is pushed into the passage with the long side and locked in place.
Before fitting, check that the opening on the inside is rectangular and has no misalignment.
If this is the case, the outer barrel must be aligned straight.
- Remove the two screws on the fore-end and pull it forward.
- Loosen the barrel groove a little so that the outer barrel is slightly loose.
- The adapter can now be installed and the barrel groove tightened again.
- The adapter also serves as an alignment for the outer so that it does not twist when the groove is tightened.
Designed by REAPERs Airsoft. Further information can be found in the review video by REAPERs Airsoft from 02:11:33
With this adapter, for example, our Begadi NEPTUN CNC HopUp Unit can be used in both guns.
The adapter uses the front passage (cable guide) to extend the outer barrel.
It is pushed into the passage with the long side and locked in place.
Before fitting, check that the opening on the inside is rectangular and has no misalignment.
If this is the case, the outer barrel must be aligned straight.
- Remove the two screws on the fore-end and pull it forward.
- Loosen the barrel groove a little so that the outer barrel is slightly loose.
- The adapter can now be installed and the barrel groove tightened again.
- The adapter also serves as an alignment for the outer so that it does not twist when the groove is tightened.
Designed by REAPERs Airsoft. Further information can be found in the review video by REAPERs Airsoft from 02:11:33
Review Partner